Bolens 2182 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION VI. MOWING
MOWING
A
WARNING
To avoid possible injury, do not allow any
one in the area opposite the discharge chute
while mowing. Although the area has been
supposedly cleared of foreign objects, small
objects may be discharged by the mower.
A
WARNING
Never direct discharge of material toward
bystanders or allow anyone near the
machine while in operation.
For best results it is recommended that the first two
laps should be cut with the discharge thrown towards
the center. After the first two laps, reverse the direc
tion to throw the discharge to the outside for the bal
ance of cutting. This will give a better appearance to
the lawn.
Do not cut the grass too short, as the mower will tend
to scalp the grass. Short grass invites weed growth
and yellows quickly in dry weather.
Mowing should be done with the engine at full throttle.
Do not mow at high ground speed.
During certain times of the year and under some con
ditions, the mower may leave streaks of uncut
material.
Streaking may occur when attempting to mow heavy
weeds and tall grass. Under these conditions it may
be necessary to go back over the cut area a second
time to get a clean cut.
The following practices will help eliminate streaking:
1. Mow the area more often so the grass doesn’t get
too tall and heavy.
2. Operate the tractor at full throttle and lower for
ward speeds.
3. Keep the blades sharp and replace blades when
worn.
4. Follow the mowing procedure shown in Figure 47.
32