Bolens 2182 - Manual (Page 22)

FRONT WHEEL ADJUSTMENTS
Check the front wheels to ensure that the turning
radius of the unit is equal in both directions. Turn the
wheels all the way to the left. Measure the angle of
the wheel to the frame. Turn the wheel all the way to
the right and repeat the measurement. The angles
shall be equal.
NOTE
Power steering components are under
hydraulic pressure. If not properly adjusted,
serious damage may occur to steering com­
ponents.
For adjustments on front wheels, see your authorized
Cub Cacfef dealer.
PIVOT BAR ADJUSTMENT BOLTS
CAUTION A
The tractor must be checked every 50 hours
of tractor operation for play between the
front axle and the pivot bar adjustment bolts.
The adjustment bolt heads must fit against
the front axle. If play is discovered, the pivot
bar adjustment bolts must be adjusted.
If play is discovered between the front axle and the
pivot bar adjustment bolt heads, adjust both bolts as
follows: (See Figure 33.)
1. Loosen jam nut 3 to 4 turns or as required.
2. Turn pivot bar adjustment bolt counterclockwise
until it hits against the front axle.
3. Tighten jam nut.
4. Repeat the above steps for the other pivot bar
adjustment boit.
CARBURETOR ADJUSTMENTS
A
WARNING
If any adjustments are made to the engine
while the engine is running (e.g., carbure­
tor), disengage all clutches and blades.
Keep clear of all moving parts and be careful
of heated surfaces and muffler.
A
WARNING
To avoid injury or an accident, engage single
pedal brake lock, place speed control lever
in neutral and make sure equipment is
disengaged before starting engine to make
carburetor adjustments.
A
WARNING
Carbon monoxide fumes can be fatal! Do
not make any adjustments to the carburetor
in a confined area such as a storage build­
ing. Move the tractor outside into the air.
NOTE
In this manual the tractor covered is
equipped with a fixed jet carburetor.
Figure 33
1. Jam Nut
2. Pivot Bar Adjustment Boits
3. Front Axie
22