Bryant PAYNE 619C - Manual (Page 15)

NOTES FOR FIG. 20 AND 21
1. Compressor and fan motor are thermally protected.
2. Wire in accordance with National Electrical Code (NEC)
and local codes. If any of the original wire must be re­
placed, it must be replaced with type 90 C wire or its
equivalent.
3. Use minimum of 60 C wiring for field power wiring.
4. Thermostat is internal to unit. Unit must be controlled
with wired or infrared wireless remote controller.
5. Use copper conductors only.
LEGEND FOR FIG. 20 AND 21
ASM
_
Air Sweep Motor IDC TH
_
Indoor-Coil Thermistor Circuit Board Run
ASR — Air Sweep Reiay IFM — Indoor-Fan Motor
C _ Compressor Contactor LPS — Low-Pressure Switch Terminal Marked
CAP — Capacitor OATTH — Outdoor Air Thermistor
o CB — Circuit Breaker OCTTH — Outdoor Coil Thermistor Terminal Unmarked
CH — Crankcase Heater OFM — Outdoor Fan Motor
COMP — Compressor OFR Outdoor Fan Relay • Splice
DATTH — Discharge Air Thermistor PCB — Printed Circuit Board
DTS — Discharge Temperature Sensor PL — Plug 1 >■ 1 Terminal Block
EQUIP — Equipment Ground RA TH — Return Air Thermistor
GND RVS Reversing Valve Solenoid Factory Wiring
FL — Fuse Link SC — Start Capacitor
HPS — High-Pressure Switch SR Start Relay
Field Control Wiring
HR —
Heater Relay TB
—
Terminal Block
Field Power Wiring
HTR — Heater TDR
-- Time-Delay Relay
HTT Heater Temperature Thermostat TRAN
—
Transformer Accessory or Optional Wiring
-
15
-