Bolens 120-337A - Manual (Page 16)

11. Reassemble in reverse order with the new
belt, making certain the idler pulley is under
the belt. See figure 38.
NOTE
When reinstalling the chain, be sure
the closed end of the master link
clip faces in the direction of chain
travel.
HANDLE STORAGE
The handle can be stored in an upright position to
take less space. Move hairpin cotters to outer hole
on weld pins (see figure 3). Grasp the lower handle
at the bottom and pull apart slightly. Tip the han­
dle forward. It will lock in this position. Reverse
this procedure to place the handle in the
operating position.
The handle on this model may also be folded away
completely for storage.
1. Remove hairpin cotters from inner hole on
weld pins on handle rhount brackets. Place in
outer hole.
2. Loosen the hand knobs on each side of the
handle.
3. Press outward on the bottom of each side of
the lower handle, and push forward.
4. Fold the upper handle back and down.
To take the handle out of storage position, pro­
ceed as follows.
1. Lift the upper handle up and towards the rear.
2. Pull the handle back until it locks into the
operator’s position.
3. Tighten the two hand knobs securely.
4. Move the hairpin cotters to the inner hole on
the weld pins.
OFF-SEASON STORAGE
If the machine is to be inoperative for a period
longer than 30 days, the following procedures are
recommended;
1
,
Working outdoors, drain all fuel from the fuel
tank. Use a clean dry cloth to absorb the small
amount of fuel remaining in the tank. Then run
the engine until all fuel in the carburetor is ex­
hausted.
^ WARNING J
Do not drain fuel while smoking, or
if near an open fire.
2. Drain all the oil from the crankcase (this
should be done after the engine has been
operated and is still warm). Refill the
crankcase with clean new oil.
3. Disconnect the spark plug wire and remove
the spark plug from the cylinder. Pour about 2
or 3 tablespoons of engine oil into the
cylinder. Turn the engine over several times to
spread out the oil. Replace the spark plug, but
do not connect the wire.
4. Clean the engine and the entire mower
thoroughly.
5. Lubricate all lubrication points.
16