Warning i, Figure 36, Pulley i – Bolens 120-337A User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Remove the belt from the idler as you lift off
the belt guard.
5. Remove hex nut and lock washer from height
adjustment lever on left side of mower as
shown in figure 33.
Hex Nut
Lock Washer
FIGURE 33.
6. Place the mower on its side.
(^) t, Wfti
♦ ♦
WARNING I
Make sure that the mower is secure
and cannot tip over.
7. Remove two screws, nuts and lock washers.
Remove one hex nut and lock washer from
cover plate. See figure 34.
FIGURE 34.
8. Remove the cover plate. See figure 35.
FIGURE 35.
9. Remove the master link from the chain. See
figure 36.
Chain
Master
Link-
FIGURE 36.
10. Remove the chain, pulley shaft and belt. See
figures?.
Pulley
i
Shaft'
^
FIGURE 37.
15