Canon WITE32 - Manual (Page 21)

WITE32 Release Notes Version 3.11
The Errors at The
Test End check
box If the check box is checked, no error messages during the
production test will be shown. The buffered messages will be
shown in a separate dialog box at the end of the production test.
Moreover, the buffered messages will be appended to a log file.
The Error Log File
Name text box The text box shows the log file name with a path.
The file open
button “…” When the button is clicked, a File Open dialog box is shown. You
can specify the path and file name for the log file.
3. If the Errors at The Test End check box is enabled in the Configure | Test Options… dialog box, the full
information on every error is included to the detailed error output, which is shown in the More Info mode of the
standard WITE32 error message box (see Figure 16 above). In previous versions of WITE32, only the basic error
information is shown in the More Info mode when the Errors at The Test End option is enabled.
2.8 Head Selection in the WITE32 Engineering Dashboard
The behavior of the Head selection frame of the WITE engineering dashboard is changed. If you change the
maximum number of heads in the Head No field of the Maximum Limit frame of the Configure | Device dialog box,
then:
1. All heads selected in the Head Selection table of the Configure | System dialog box, with numbers more than
the maximum head number, are deselected.
2. If all heads become deselected as a result of changing the value of the maximum number of heads, then the
Head 0 is selected.
3. If the number of the current head in Head frame of the WITE32 Engineering Dashboard is more than the
new value of the maximum number of heads, a head from the list of selected heads with a maximum number
is set as the current head.
Guzik Technical Enterprises 21