Canon WITE32 - Manual (Page 18)

WITE32 Release Notes Version 3.11
• The Use CCW Micro Actuator Parameters check box indicates that CCW parameters will be applied to the
CW Micro Actuator. Please enable this check box if configurations of both CW and CCW actuators are
identical, such that you do not have to configure the same parameter twice.
The parameters of the CCW and CW micro actuators can be configured independently, or you can apply the CCW
Micro Actuator Parameters to the CW Micro Actuator by enabling the CCW Micro Actuator Parameters check box.
2.3.3 XY Alignment Test
1. The XY Alignment test behavior has been changed. After performing the test in the manual mode (from the
stopped device), the spinstand leaves the head loader in the position where it was placed by the user. No
movement to the home radius is performed.
2. The new read-only control Cartridge Angle is added to the XY Alignment test configuration dialog box to display
the angle of the cartridge for which the XY alignment is being performed. Please refer to the section 2.3.2.3 for
more details on the cartridge angle.
Figure 14 XY Alignment Test Configuration Dialog Box
All Head Parameters controls are made read-only, since they are shown on the XY Alignment configuration form
for the reference purpose only. Starting from WITE32 version 3.11 you must use the Product Parameters dialog
box of the WDCP2002 program to change these values.
2.4 New Installation Procedure For Guzik PCI Boards
The WITE32 installation program version 3.11 contains a new revision and a modified installation procedure of the
PCI driver. The procedure introduces the following features:
• The special procedure to eliminate a conflict with on-board USB 2.0 controller is no longer required. Please
refer to section 7.1 "Windows 2000 Crashes After Installation of WITE32" of WITE32 Release Notes
Version 3.10 document for the description of the special procedure.
• In most cases, the installation of a new version of WITE32 and/or Guzik Technical Enterprises PCI boards
does not require to reboot a computer.
Guzik Technical Enterprises 18