Pentax me super - Manual (Page 6)

23903 Page 5 of 32
5. Check of Shutter block (0-E000) by using T-adjuster
It is prohibited to adjust the curtain speed and the shutter speed in
0-E000. If the curtain speed and the shutter speed was out of
tolerance, replace Shutter block (0-E000) to new one.
The curtain speed and the shutter speed must be checked before install
the mirror housing to the body.
*The curtain speed is especially important for 23903 so that l/2000sec.
is adopted.
*The auto-manual speeds are already decided on T100. The auto-manual
speeds which decided on T 100 can not get if the adjustment of timing
switch in 0-E000 was no good.
Insert Connector (23900-I 100) to
Adapter for T-adjuster. Distribute
lead wires as shown left.
To actuate the auto-manual hutter,
install temporary top cover and
set the shutter dial AUTO or M, or
insert 2 mm diameters pin between
C14-01 and C24.
6. Time-sequence of SWg and SWm
It is requested that Adapter for checking the time-sequence of SWg and
SWm should be made by your own side.
Adjusting procedures and the tolerance are the same as 23900.
7. P.C. board pattern (T100)
1)
LED part
LED retainer collar (T212)
CNL-D 1.4 x 2.5
Confirm that LED insulation seal (I18) was sealed on the back side of
LED supporting plate.