Lexicon MX200 - Manual (Page 30)

M MXX220000 U Uttiilliittiieess
buttons simultaneously.
2. Press the Audition button repeatedly
until In appears in the Program
Display. The Program Display flashes
betweenIn and dI if the digital input is
selected. If you want to disable the
digital input and use the analog inputs,
turn the Program Select knob until the
Program Display reads An to select the
analog input.
3. Press the Store button to save this
change.
Digital Out Dry Track
The MX200 can send unprocessed digital
audio (Dry Track) out the S/PDIF Digital
Out while monitoring processed audio
through the analog outputs. This is useful
when you want to record a dry perform-
ance digitally, but also hear effects pro-
cessing while you a recording.
Note: The Dry Track feature is only avail-
able for signals brought into the MX200 via
the analog inputs. Dry Track has no effect
on signals being received at the S/PDIF In.
Digital in/out signals are processed normal-
ly regardless of whether the Dry Track
parameter is enabled or disabled.
To enable Dry Track:
1. Press both the Store and Audition
buttons simultaneously.
2. Press the Audition button repeatedly
until dt appears in the Program
Display. The Program Display flashes
between dt and Of
3. Turn the Program Select knob until the
Program Display reads On to enable
the Dry Track feature.
4. Press the Store button to save this
change.
Stereo and Mono Output
Modes
The MX200 outputs can be either Stereo
or Mono depending on your application
needs. When Stereo Output Mode is
selected (MX200’s default Output Mode),
the signals maintain stereo separation as
configured by the Routing button. When
Mono Output Mode is selected, both Left
and Right output signals are summed to
mono and then sent out the Left output.
To select Mono or Stereo Output Modes:
1. Press both the Store and Audition
buttons simultaneously until Ut appears
in the Program Display.
2. Press the Audition button repeatedly
until OP appears in the Program
Display. This is the Output Mode setup
menu.The Program Display
alternately flashes OP and then St
to indicate Stereo Output Mode is
selected.
3. To change the Output Mode to Mono,
turn the Program Select knob until no
appears in the Program Display
indicating Mono Output Mode is now
selected.
4. Press the Store button to save these
changes.
Note: When Mono Output Mode is select-
ed, effects like Panner and Pong Delay will
no longer have left to right animation as
they do when Stereo Output Mode is
selected.
Factory Program Banks:
Serial and Parallel
The MX200 has two sets of Factory pro-
gram banks: the Parallel bank and Serial
bank. The Parallel processing bank is used
when the MX200 is configured in an
Auxiliary Send/Return setup with a mixer.
The Serial bank is designed for use when
24