Checking engine oil level, Change engine oil, Change oil filter – Generac Power Systems 0940-1 User Manual
Page 13: Engine air cleaner, Change oil filter engine air cleaner -12, Maintenance
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MAINTENANCE
This section includes information about sirtiple main
tenance which includes the following tasks;
• Checking engine oil level.
• Changing engine oil.
• Changing oil filter.
• Air cleaner maintenance.
• Cleaning the air intake screen.
Cleaning spark arrestor.
• Cleaning spark plug.
Replacing fuel filter.
Servicing inverter.
CHECKING ENGINE OIL LEVEL
Check engine crankcase oil level at least every eight
hours of operation, or before each use (Figure 2).
• Be sure the generator is as level as possible.
• Remove oil dipstick and wipe dry with clean, lint-free
cloth.
• Install and tighten oil dipstick, then remove again.
• Oil should be at dipstick FULL mark. If necessary, add
the recommended oil to the FULL mark only. DO NOT
FILL ABOVE “FULL" MARK.
• Install and tighten oil dipstick cap before operating the
engine.
Figure 2 — Oil Dipstick and Fill Tube
NOTE: See “Engine Oil Requirements” on Page 10
for recommended oils.
CHANGE ENGINE OIL
Change engine oil after the first 8 hours of operation.
Thereafter, change oil every 50 operating hours.
Change oil more frequently if operating consistently
under heavy load or at high ambient temperatures.
• Warm up engine for at least five minutes, then shut down.
• With engine still warm from running, clean area around
' oil drain plug and remove oil drain plug (Figure 3). Drain
oil completely into a suitable container.
• When oil has drained, install and tighten drain plug.
• Remove oil dipstick and fill crankcase with the recom
mended oil (See Page 10). The engine crankcase can
hold about 1 quart (950ml). DO NOT FILL ABOVE “FULL”
MARK.
• Install and tighten dipstick cap before operating engine.
CHANGE OIL FILTER
Replace the engine oil filter after the first 8 hours of
operation, every 50 operating hours thereafter.
• Turn oil filter counterclockwise to remove (Figure 3).
Figure 3 — Oil Drain Plug and Engine Oil Filter
• Turn new filter clockwise until its gasket contacts lightly
with the filter adapter. Then tighten an additional 3/4 to
one turn by hand.
• Run engine and check for leaks.
NOTE: Check oil level and fill to full mark after
checking for leaks. Filter will retain some oil.
ENGINE AIR CLEANER
Paper Filter: Once every 25 operating hours or once
each year (whichever comes first), clean or replace
the paper filter (Figure 4). Follow the steps on page
12
.
Figure 4 — Engine Air Cleaner Assembly
— 1 1 —