Make sure that the power cord is unplugged – NordicTrack NTL14010.0 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Make sure that the power cord is unplugged.
Place a piece of cardboard below the rear of the
Frame (56) to protect the floor or carpet.
Attach the Lett Wheel Cap (96) to the Base (97)
with two #8
X
3/4" Screws (1).
Attach the Right Wheel Cap (not shown) to
the right side of the Base (97) in the same
way.
2. Pull the Upright Wire (84) and the Base Ground
Wire (94) through the indicated hole in the Base
(97).
Attach the Base Ground Wire (94) to the Base
(97) with a #8
X
1/2" Ground Screw (9).
3. Identify the Lett Upright (89), which is marked
with a “Left” sticker. Have a second person hold
the Lett Upright near the Base (97).
See the inset drawing. Tie the wire tie in the
Lett Upright (89) securely around the end of the
Upright Wire (84). Then, pull the other end of the
wire tie until the Upright Wire is routed com
pletely through the Lett Upright.