The set of hemmers, Hemmer set, Hemmers -49 – SINGER W1065 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
48
THE SET OF HEMMERS
Before
attaching
any
of
the
hemmers.
Be
sure
bobbin thread is pulled up. Then, with hemmer m
place, hold top thread loosely and turn handwheel one
full turn toward you, making a loop under hemmer.
Grasp
bobbin
thread
with
both
hands
and
slip
horizontally
under
hemmer
toward
back.
Bobbin
thread will catch loop and carry upper thread to back
of hemmer.
Fold material to suit for two inches along edge,
hold at each end of fold.
Slip fold into guide and
up over spoon (Fig. 88). Fold hem in material back of hemmer
and fasten with point of needle. Pull on threads gently as you start stitching.
Draw forward to end of hem
H E M M E R S E T
You can make a hem 1/4^ 3/8^ 5/8'' or 7/8" in width, depending upon
which hemmer you use. For a few of the many uses see Fig. 89, 90, 91, 92,
93 and 94.