Embroidering with a hoop, Embroidering with a hoop u – SINGER W1065 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
30
Apply the above method to sew on buttons with four holes, hooks, snaps
If a four hole button is to be sewn follow the same procedure above for
the two hole button.
Now lift presser foot slightly and move fabric to permit stitching the re
maining two holes.
Hooks, snaps, and etc. are sewn to the fabric with the same procedure as
for sewing the two hole button.
EMBROIDERING WITH A HOOP
It is easy to follow a stamped design or to work
free hand when embroidering or monogrammmg.
See Fig. 54 . Release the pressure from the foot
by pressing down the snap lock on the automatic
darner. Push the drop feed button down all the
way.
Stretch the fabric in an embroidery hoop, and
place under the needle after removing the presser
foot Set the stitch width at the size you prefer
i
and lower the presser bar lifter. Then operate the machine at a rather high speed while
the hoop slowly with both hands. Work carefully and be sure to keep fingers out of the path
'sLTd you encounter skip stitches the fabric is not stretched tight enough or a darning spring
IS needed <,see attachments available from your dealer illustrated in the back of this book. ^
Fig. 54