Choosing and changing accessories, Changing the needle, Changing presser feet snap-on presser feet – SINGER 6136 User Manual
Page 6: To remove and replace fool, Isîmptmr z:. reaclÿ to kmw
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
iSîmptMr Z:.
Reaclÿ to kmw
choosing and changing accessories
CHANGING THE NEEDLE
• Raise needle to its highest point by turning
the hand wheel toward you. Loosen needle
clamp screw A and remove the needle.
• Insert new needle up into clamp B as far
as it will go, with the flat side of the needle
to the back.
• Tighten noodle clamp screw.
Flat Side to Back
CHANGING PRESSER FEET
Snap-on Presser Feet
'ihe presser feet furnished with your machine liaise needle to highest position by turning the
snap on and off a common shank.
hand wheel toward you. Raise pressor foot.
To Remove and Replace Fool
fa. Press toe of presser foot upward as far as 1P. Then snap down to remove
it will go.
2. Centre the new pressor foot under tfie shank 3. Press pressor foot screw down firmiy until
C and towor tho proasor foot fifior so that foot snaps into placo.
the shank fits over the presser foot pin.