Procedure, Step 1: side stitching, Step 2: bar tack – SINGER 8019 User Manual
Page 46: Step 3: side stitching, Step 4: finai bar tack, Step 5: fastening stitch
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CB'
Procedure
Place work under needle, aligning centre
marking of buttonhole with the black line in
the center of the special purpose foot.
step 1: Side Stitching
Position needle in fabric at point A. Lower the
foot and stitch to end of marking. Leave
needle in fabric at point B. Raise foot and
pivot work on needle. Lower the foot. Take
one stitch without changing stitch width
setting, bringing work to point C.
step 2: Bar Tack
Adjust stitch width selector for bar tacks, and
take about six stitches. Stop at point D.
step 3: Side Stitching
Readjust stitch width selector for side stitch
ing. Complete work to point E. Leave needle
in fabric,
step 4: Finai Bar Tack
Adjust Stitch width selector for bar tacks, and
take about six stitches ending at point F.
step 5: Fastening Stitch
To secure stitching, move stitch width selec
tor to i and take three stitches. Remove
work, draw threads to underside, fasten, and
trim. Cut opening for button with sharp
scissors.
44