Threading the machine – SINGER 8019 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading The Machine
1. Raise presser foot and be sure needle is in
its highest position.
2. Place spool of thread on horizontal spool
pin. If spool being used has a retaining slit,
this should be placed to the right.
3. Press appropriate thread lead-off holder
firmly against spool.
A. For large spools of thread, use the large
holder with the wide end against the
spool.
B. For medium size spools, use the large
holder with the narrow end against the
spool.
C. For small diameters spools with either
large or small quantities of thread, use
the small lead-off which comes in your
accessory box.
4. Lead thread from spool holder and snap It
down Into guidepost eyelet
a.
5. Hold thread down under finger, as illus
trated, and lead thread-under rear thread
guide
b,
behind pre-tension disc, and
across slot in top of machine.