Turning square corners, Turning square comers – SINGER 14U52 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
22. Turning square corners
Outside corner
1. Cut out approximately
2cm from the comer in
line with the overedge
seam edge.
2. Sew to point A, one stitch
beyond edge of fabric and
stop machine.
3. Raise needle and presser
foot.
4. Pull fabric to the rear of
machine just enough to
release the thread caught
on the finger of the throat
plate.
5. Turn fabric and lower
presser foot so that its
finger is positioned on the
edge of fabric.
6. Pull slack threads up, then
start to sew.
Inside corner
1. Cut fabric at seam edge.
2. Place movable knife in
non-operating position.
3. Fold fabric as shown in
sketch.
4. Sew to point B, as close as
possible to the diagonal
fold. Leave needle in
fabric.
5. Raise presser foot, leaving
the needle in the fabric.
6. Refold fabric so that the
overedge is in line with the
already sewn seam.
29