2) thread the left looper (yellow path) – SINGER 14U52 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Remove cylinder cover and thread left looper in the order 0 to
path) (See page 8 for cylinder cover removal)
While holding thread with finger, wrap
thread around tension disk clockwise
till
caught in hook and pull thread
down to make certain it is properly
located in between the tension discs.
(2) Thread the left looper (yellow path)
shown below. (Yellow thread
Turn hand wheel toward you
until left looper is at left as far
as it will go and thread the
looper thread hole (9) from left
to right. (Use tweezers provided
in your accessory set).
Turn hand wheel toward you
until the looper is at right as far
as it will go passing the thread
under the throat plate, then
using the tweezers, thread the
looper thread hole (f^ from
front to back.
Place the thread over the top of the right looper and
hold the thread while initially sewing.
11