SINGER W571 - Manual (Page 39)

38
THE SET OF HEMMERS
Before .tteching eny of the hemmere, bo sme
bobbir. Ihreed is pulled up. Then, with henrmer in
piece, hold top thread loosely end turn hand wheel
one lull turn toward you, making a loop unde,
hemmer. Grasp bobbin thread with both
slip horizontally under hemmer toward back Bobbr
thread will catch loop and carry upper thread to
back of hemmer.
Fold material to suit for two inches along edge
hold at each end of fold. Slip fold into g hemmer. Draw forward to end of hem
rViri B2') Fold hem m material back ol nemi
np over spoon (Fig 62). ^uj^hing.
and fasten with point of needle, run
H E M M E R S E T
1. 1 /A" 2/R" 5/8" or 7/8" in width, depending upon
You can make a hem 1/4 , 3/8 , b/d , or
which hemmer you use. For a few ol the many uses see Frgs.