SINGER 513 Stylist - Manual (Page 56)

CARING FOR YOUR MACHINE (Continued)
REfVlOViNG AND REPLACING
BOBBIN CASE
Raise presser foot.
Turn hand wheel toward you until
needle is in its highest position.
Open slide plate with downward finger
pressure. Draw plate toward you,
opening it all the way to raise the
needle plate locking pin.
Rennove needle plate.
Remove bobbin.
(O Bobbin Case
Holder
Bobbin Case
Removing Bobbin Case
To remove bobbin case“
Turn bobbin case holder to back as far as
it will go. Lift out bobbin case.
To replace bobbin case:
Guide the forked end under the feed and
then draw the bobbin case under the
position plate as illustrated. Turn bobbin
case holder all the way forward to lock
bobbin case in position. After locking the
bobbin case in position, check that the
bobbin case does not bind but has slight
rotational movement.
® Replace bobbin in bobbin case,
® Replace needle plate.
® Close slide plate to lower needle plate
locking pin and secure needle plate.
54