SINGER 513 Stylist User Manual

Page 53

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

(Off)

© Pattern Selector: Any setting

® Needle Position : X
© Stitch Width : !

© Stitch Length : In Fine Area

© Feed-Cover Needle Plate

© No Presser Foot

© Presser Bar: Lowered

Remove presser foot w i t h shank (by

removing the screw which fastens the
shank to the presser bar). Attach feed-
cover

needle

plate.

Instructions

for

changing the needle plate are given on

page 7.

1. Trim ragged edges from area to be

darned.

Center worn section in embroidery

hoop,

3. Position work under needle over feed-

cover plate and lower presser bar to
engage tension.

4. Hold needle thread loosely with left

hand, turn hand wheel over and draw
bobbin thread up through fabric. Hold
both thread ends and lower needle

into fabric.

5. Outline area to be darned with running

stitches for reinforcement.

6. Stitch across opening, moving hoop

under needle at a slight angle from
lower left to upper right. Keep lines of

stitching closely spaced and even in

length.

7. When opening is filled, cover area with

crosswise lines of stitching.

This method of controlling fabric move

ment with an embroidery hoop may be

used to do embroidering and mono-
gramming.

Darning With Embroidery Hoop