SINGER 513 Stylist - Manual (Page 55)

removing covers, bobbin case and
CAUTION: Before removing covers,
disconnect power-line
REIViOViWO AMD REPLACING
TOP COVER
© To remove, loosen and remove screv\/s
A and lift off top cover.
® To replace, position cover on top of
machine and replace and tighten
screws A.
REIVlOViNG AND REPLACING
BOTTOIVl COVER
If your machine is a portable, remove the
carrying case base as instructed below.
® To remove, tilt machine back and re­
move retaining nut B, being careful not
to lose felt washer, and remove cover
from underside of machine.
® To replace, position cover over bottom
of machine and replace felt washer and
retaining nut Tighten retaining nut
with a screwdriver.
REMOVING AND REPLACING
CARRYING CASE BASE
® Turn machine so that back is toward
you. Tilt machine back and loosen and
remove the retaining nut B from the
center.
® Set machine upright and lift up and out
of base.
® Replace machine in base, after bottom
cover has been attached.
® Turn machine so that back is toward
you; tilt back and replace retaining nut.
Tighten retaining nut with a screw­
driver.
REMOVING AND REPLACING
FACE PLATE
® Loosen and remove screw D and re­
move face plate by sliding it downward.
® Replace face plate by sliding top edge
of plate under edge of arm top cover.
® Align screw hole in plate with screw
hole in machine and replace and
tighten thumb screw D.
case,
from electrical
O
O
53