SINGER 319K - Manual (Page 84)

82
BIAS BOUND EDGES
ADJUSTING
LUG
OUTSIDE
SLOTS FOR
DIFFERENT
WIDTHS OF
FOLDED
BINDING
SCROLL FOR
UNFOLDED
BINDING
CENTER SLOT
OF SCROLL EDGE GUIDE
FOR PIPING
ONLY
Fig.150. Multi-slotted Binder
Fig. 151. Applying Binding to Garment
The Multi-slotted Binder is provided with a wide throat to
accommodate zigzag as well as straight stitching. Zigzag stitched
binding affords an elastic and durable flat finish for curved, scal­
loped or pattern edges. The Binder will apply prefolded bias
binding in sizes 1, 2, 3, 4 and 5, as well as self-fabric bias cut to
1^6 inch width. Bindings are fed through slots of corresponding
size'in the Binder scroll.
Use: All-purpose Throat Plate and Multi-slotted Binder
Central Needle Position
2 to 5 Bight
12 to 8 Stitch
Lever A
To thread Binder, cut binding to a long point from
edges to center fold as shown in Fig. 152.
Insert pointed end of binding into appropriate slot
for its width and pull binding through until the
evenly folded edges are under needle.
Slip free length of binding between two upright pins
which act as a guide for lightly feeding binding into
Binder while it is being stitched. Place raw edge to
be bound as far to right as it will go into mouth of
scroll, guiding fabric lightly from back of Binder
and to the left, permitting unfinished edges to
swing naturally into scroll of Binder.
Fig. 152