SINGER 319K User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
38
TO REGULATE BOBBIN THREAD TENSION
The tension on bobbin thread is regulated by
the larger screw nearest the center of the ten
sion spring, as shown in Fig. 61.
When adjusting bobbin thread tension, a slight
turn of the screw is all that is needed to make
a fine adjustment, because the full range of
tension from zero to a maximum is made
within IM turns of tension regulating screw.
To increase tension, turn this screw gradually
over to the right.
To decrease tension, turn this screw gradually
over to the left.
Balanced Tensions
This manual is related to the following products: