SINGER 319K - Manual (Page 73)

71
TO SEW ON SNAPS AND HOOKS AND EYES
No Presser Foot is used for sewing on snaps. Instead,
hold snap in place with tweezers, stiletto, or the point of
embroidery scissors.
Lower the feed as instructed on page 70.
Use: All-purpose Throat Plate
Left Needle Position.
0 Stitch setting
2 Bight
Lever A
£ZU39
Fig. 127
Sewing on Snaps and Hooks and Eyes
Turn hand wheel over by hand to bring needle in position
ready for its left swing. Center needle in first hole and
take 6 overedging stitches, leaving needle in hole at left
position on last stitch. Change bight to 0 and take 3 fasten­
ing stitches. Carrying thread across snap, center needle in
next hole and change bight to 2. Take 6 over edging stitches, then returning bight to 0, take 3
fastening stitches. Continue this process with each hole.
The same procedure and settings are followed
when sewing on hooks and eyes except that
after taking 6 overedging stitches in first hole
of hook, leave needle in center of hole and
turn work so that next 6 overedging stitches
will carry across bar of hook, then proceeding
to second hole, take 6 overedging stitches and
changing bight to 0, finish with 3 fastening
stitches.
Follow same procedure for sewing on eye,
taking 6 overedging stitches in first hole,
6 overedging stitches across to second hole,
6 overedging stitches to side of hole, and,
changing bight to 0, finish with 3 fastening
stitches.