SINGER 319K User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
21
Fig. 15
4. Hold hand wheel
H
with left hand, and
with right hand, loosen stop motion screw J
to release hand wheel from stitching mecha
nism as shown above.
Allow tension discs F, Fig. 14, to control
flow of thread so that it winds on bobbin in
uniform, level rows. Do not guide or hold
thread when winding bobbin
Thé bobbin winder will stop automatically
when the bobbin is filled. When less than a full
bobbin is desired, lift latch
D.
Remove bobbin
from spindle and retighten screw J, Fig. 15.
5. Hold end of thread and press controller
pedal as for sewing. End of thread must be
held until it breaks off.
NOTE: If bobbin does not wind evenly, loosen
which holds tension bracket F
screw
in
position and move bracket to the left if bobbin
winds high on the right; move bracket to the
right if bobbin winds high on the left. When
bracket is properly centered, thread will wind
evenly across bobbin. Retighten tension
bracket screw.
Bobbin can be wound while machine is sewing.