To regulate length of stitch, Stitch length for satin stitching – SINGER 319K User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
28
TO REGULATE LENGTH OF STITCH
Straight Stitching
—The numerals on the
left of the stitch indicator scale denote the
approximate number of stitches per inch.
Zigzag Stitching
—The lengthwise distance
between needle penetrations is controlled by
the stitch regulator.
To Reverse the Direction of Feed
—To
feed the material
toward you,
raise the lever
Q, Fig. 40
as far as it will go. The machine
will then stitch in a reverse direction, thus
making it easy to ''back stitch” and to fasten
ends of seams.
STITCH LENGTH FOR SATIN STITCHING
Fig. 40.
Stitch Length Regulator
To lengthen stitch, loosen limit screw
R
enough to allow
top
of stitch regulator lever
Q
to be lowered just below number desired.
Turn limit screw
R
until
top
of stitch lever
Q
rises to setting desired.
Fig. 41. Satin
Stitch Foot
Fig. 42. Satin Stitching
Satin stitching.
Fig. 42,
is done with stitch
regulator lever
Q
set between 25 and 0
position and with the Satin Stitch Foot
Fig. 41.