Binder – SINGER W167 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
33
B I N D E R
This attachment folds bias binding, applies it to the edge
of material in one operation. Slots on scroll of the binderare
for corresponding widths of commercial folded bias binding.
The open mouth of binder scroll is used for unfolded bias
strips cut 1 5 / 1 6 inch wide.
FOLDED BINDING
Cut a point of folded binding, insert in appropriate slot.
Draw through slot a and under binder with strong pin.
Sliding binder slot to right or left.
TWO-TONE BINDING
Two bindings can be sewn on fabric edge also in one
operation. When two are used, always skip one size between
widths, inserting each in correct size slot.
HAND CUT BIAS BINDING
Cut 15/16 inch bias binding fold in half for a couple
of
inches.
Cut
binding
diagonally
toward
end,
almost
to
fold. Slip fold into center of binder. Draw back until cut
opens and binding encircles open end of scroll. Test sitch-
ing to be sure it is on the edge adjust if necessary.
Fig. 47
Fig. 48