Sears 385.17724 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3. LEARN THE STITCHES
e Sew a Button
Sat the Machine
Stitch width control
Must be adjusted
,
2
3
Top thread tension
control 2 to 6
Stitch length control
Any number (not
necessary to adjust)
A: Zigzag toot
Darning p
Stretch Stitch
Use the darning plate for button sewing (see page 29).
1.
Match the center of the button holes to the center of the slot on the presser
foot,
2.
Adjust the stitch width so that needle will drop in each hole.
3.
Lower the foot to hold the button in place.
Turn the hand wheel by hand so that needle will enter either hole of the
button.
4.
Stitch several times.
To strengthen the shank, cut the
threads leaving a 8" tail. Bring the
needle thread down through the hole
in the button and wind it around the
shank.
Draw the thread to the bottom side
and knot.
35