Sears 247.79963 - Manual (Page 8)

Squeeze the clamp on the drawstring and pull the
drawstring tight. Release the clamp.
Drive
FIGURE 5.
ADJUSTING THE CLUTCH CABLE
• While adjusting the hex nuts at the cable
make sure that there is no slack in the
ce
the cable is not tight. See figure 5B. Do r
tighten the cable.
To check the clutch adjustment, proceed as fo
aracket,
ble, but
ot over­
lows,
forward • Push the chipper-vacuum backward and
with the drive clutch handle released. 11 should
move freely. If it does not, loosen both he> nuts at
the cable bracket. See figure 5B. Turn bo tom nut
counterclockwise to loosen the cable.
• Holding against the upper handle, engage lie drive
clutch handle and try to push the unit backward
and forward. The wheels should lock up.
• If the wheels do not lock up, loosen both hex nuts
at the cable bracket. Turn front nut clod wise to
tighten the cable.
• Recheck the adjustment. Tighten both the hex nuts
when you have adjusted it correctly.
INSTALLING THE SHIFT KNOB
• Thread the shift knob onto the end of tie shift
lever.
ATTACHING THE BAG
• Place bag Inside the handle assembly. Slip the
opening on the bag over the discharge chulé. Make
sure that it is over the rib on the discharg e chute.
See figure 6.
• Place the four straps on top of the bag over the
upper handle, hooking them on the studs. See fig­
ure 7. Make sure that the bag goes underlie drive
clutch handle. FIGURE 8.
INSERTING THE TAMPER PLUG
The handle of the tamper plug must be vertical.
• Match the angle of the tamper plug with the angle
of the chipper chute. See figure 8.
• Insert the tamper plug into the chipper chute.
NOTE: Tamper plug should remain in the chipper
chute whenever the chute is not in use.