Sears 247.79963 - Manual (Page 10)

BEFORE USING YOUR CHIPPER-VACUUM REFER TO THE
THIS MANUAL. ALWAYS BE CAREFUL
‘SAFETY RULES” AS SHOWN ON PAGE 2 OF
The operation of any chippf r-vacuum can result in foreign objects being thrown into the eyes, which
can damage your eyes severely.
Always wear the safety glasses provided with this unit or eye
shieids before chipping, cr while performing any adjustments or repairs. We recommend Wide
Vision Safety Mask for over spectacles or standard glasses available at Sears Retail Stores.
USING THE CHIPPER-VACUUM
NOTE: Your chipper-vacuum unit has a safet t switch
at the front of the housing. The nozzle or hos6 attach­
ment must be in place on the chipper-vacuum before
the engine can be started.
TO ADJUST THE NOZZLE HEIGHT
A. The height adjustment knob is located on he right
hand side of the chipper-vacuum. See figuie 10 for
its actual location. Adjusting the height fere will
also raise or lower the height of the nozzle. For
further adjustment of the nozzle height tc control
the flow, see the next section.
• Turn the knob clockwise to raise the wheels and
adjust the height of the unit.
• Turn the knob counterclockwise to lower the unit.
NOTE: Do not turn the knob too far to prevent the rod
from coming out of the ferrule.
S;
B. Your chipper-vacuum unit has a nozz e door
height adjustment lever with three sett ngs on
each side of the nozzle door. See figure 11 for its
actual location. The nozzle door height hes to be
adjusted according to the conditions.
• Slide the height adjustment lever forward (ir back­
ward for adjusting the nozzle door upwards or
downwards.
FIGURE 11.
NOTE: In general, raise the nozzle height to vacuum
a thick layer of leaves; lower the nozzle height for
smoother surfaces.
GAS AND OIL FILL-UP
OIL
Only use high quality detergent oil rated with API
service classification SF, SG or SH. Select the oil’s
viscosity grade according to your expected operating
temperature.
Colder 32‘’F -► Warmer
5W30 SAE 30
NOTE: Although multi-viscosity oils (5W30, 10W30,
etc.) improve starting in cold weather, these multi­
viscosity oils will result in increased oil consumption
when used above 32°F. Check your oil level more
frequently to avoid possible engine damage from
running low on oil.
• Use engine oil provided. Remove oil fill dipstick.
See figure 12. With chipper-vacuum level, use a
funnel to fill engine with oil to FULL mark on dip­
stick. Capacity is approximately 20 ounces. Be
careful not to overfill. Oil bottle provided contains
20 oz. of oil. Tilt chipper-vacuum toward the left
(from behind the hopper), then re-level. Check oil
level. Refill to FULL mark on dipstick if necessary.
Replace dipstick and tighten.
10