Tools needed, Unpacking, Unpacking and checking contents – Sears 113.23522 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Unpacking and Checking Contents
Tools Needed
Tools required lor alignment:
1 Combination Square
2 Combination wrench, 1/4"
Phillips tip (supplied)
Hex “L" wrench with #2
COMBINATION SQUARE
HEX “L" W/PHILLIPS WRENCH (SUPPUED)
0
1/2” SOCKET &
w i « « r I V V i *
COMBINATION SQUARE MUST BE TRUE
DRAW LIGHT
LINE ON BOARD
ALONG THIS EDGE
STRAIGHT EDGE OF
BOARD 3/4" THICK
THIS EDGE MUST BE
/pgfjpgCTLY STRAIGHT
SHOULD BE NO GAP OR OVERLAP
WHEN SQUARE IS FLIPPED
OVER IN DOTTED POSITION
Unpacking
WARNINGi To avoid injury from unexpected
starting or electrical shock, do not plug the
power cord into a source of power during
unpacking and assembly. This cord must
remain unplugged whenever you are working
on the saw.
Model 113.235220, 113 235240 and 113-235110 Miter
saws, are each shipped complete in one box.
NOTE: This manual gives instructions for both
113 235220 & 113 235240 compound miter saw and
113.235110 non-compound miter saw. The two saws
are very similar in design and function Many parts are
identical. The illustrations will reflect the compound
miter
saw
when
describing
most
applications.
Illustrations of the non-compound miter saw will also be
given to explain the features that are unique to that
saw
WARNING: Although smait, this saw is heavy,
to avoid back injury, get help whenever you
have to lift the saw more than 10 inches.
1 Remove the miter saw from the carton by lifting the
saw by the carry handle.
WARNING: If any part Is missing or damaged,
do not plug the saw in until the missing or
damaged part is correctly replaced. To avoid
electric shock, use only identical replacement
parts when servicing double insulated tools.
2 Place the saw on a secure stationary work surface
and look the saw over carefully