Sears 113.23522 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Motor Specifications and Electrical Requirements (Continued)

DANGER: To avoid electrocution;
1. Use only identical replacement parts when

servicing a tool with double Insulation.
Servicing should be performed by a qualified
service technician,

2. Do not use in rain or where floor is wet.
This tool is intended for indoor residential use

only.

Motor Safety Protection

IMPORTANT: To avoid motor damage, this motor
should be blown out or vacuumed frequently to keep
sawdust from interfering with normal motor ventilation.

1 Connect this too! to a 120v, 15-amp branch circuit

with a 15-amp time deiay fuse or circuit breaker.

Using the wrong size fuse can damage the motor

2. It the motor won’t start, release the trigger switch

immediately UNPLUG THE TOOL, Check the saw
blade to make sure it turns freeiy If the blade is free,
try to start the motor again, if the motor still does not
start, refer to the “Motor Trouble-Shooting Chart."

3. If the motor suddenly stalls while cutting wood,

release the trigger switch, unplug the tool, and free

the blade from the wood. The motor may now be

restarted and the cut finished.

4. Fuses may “blow" or circuit breakers may trip fre

quently if:

a. Motor Is Ovsrloadsd-Overioading can occur If

you feed too rapidly or make too many start/stops

in a short time,

b- Una voltages are more than 10% above or below

the nameplate voltage For heavy loads, however,

the voltage at motor terminals must equal the volt
age specified on nameplate

5, Most motor troubles may be traced to loose or incor

rect connections, overload, low voltage (such as
small size wire in the supply circuit) or to overly tong
supply circuit wire Always check the connections,
the load and the supply circuit whenever motor
doesn’t work well. Check wire sizes and length with
the Wire Size Chart below

Wire Sizes

NOTE: Make sure the proper extension cord is used
and is in good condition.

The use of any extension cord will cause some loss of

power. To keep this to a minimum and to prevent over

heating and motor burn-out, use the table below to
determine the minimum wire size (AWG.) extension
cord

Length of the

Conductor

Wire Sizes Required for 120v

(American Wire Gage Number)

110-120V

0-25

26-50