Sears recommefids the following accessories, Troubleshooting – Sears 113.235501 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sears recommefids the following accessories
,l6m
Sears Number
Leg Set......................................................................................9-22244
Blades ... See Catalog - For 5" long, Pin end type blades
Plain End Blade Adaptor.........................................9-22257
Sears may recommend other accessories not listed in
manual. See your nearest Sears store for other accesso
ries.
■
Do not use any accessory unless you have received and
read complete instructions for its use.________________
WARNING: Use only accessories recommended
for this saw. Using other accessories may be dan
gerous.
troubleshooting
WARNING: For your own safety, turn switch “OFF”, remove key and remove plug from power source outlet
before troubleshooting your scroll saw.
____________________
PROBLEM
PROBABLE CAUSE
REMEDY SUGGESTED
Breaking Blades.
1.
Wrong tension.
2. Over working blade.
3. Wrong blade application.
4. Twisting blade in wood.
1.
Adjust blade tension.
2. Reduce feed rate.
3. Use narrow blades for cutting thin wood, wide
blades for thicker wood.
4.
Avoid side pressure on blade.
Itiotor will not run
i
1. Damaged cord or plug.
2 .
Damaged motor
1.
Replace damaged parts before using saw again.
2.
Consult Sears Service. Any attempt to repair this
motor may create a HAZARD unless repair is done
by a qualified service technician. Repair service is
available at your nearest Sears Store.
Vibration
NOTE: There will
always be some
vibration present
when the saw is
running because
of
the reciprocatmg
motion of the blade.
1.
Improper mounting of the
saw
1.
2.
Unsuitable mounting surface.
3.
Loose table.
4.
Loose motor mounting.
5.
Loose eccentric coupling
(See Repair Parts List, Key
No. 35).
1.
See mounting instructions in this manual for proper
mounting technique.
2.
The heavier your workbench is, the less vibration
will occur. A plywood wortibench will not be as good
a work surface as the same size solid lumber. Use
common sense in choosing a mounting surface.
3.
Tighten table lock knob.
4.
Tighten motor mounting screws.
5.
Tighten set screw on eccentric coupling.
Blade Runout -
Blade not in-line
with arm motion.
1. Blade holders not aligned.
1.
Loose screws holding blade holders
to
arms. Adjust
position of blade holders. Retighten holders.
19