Sears 113.235501 - Manual (Page 12)

moyntlng the scroll saw to a bench
1. When mounting this saw to a workbench a solid
wood bench is preferred over a plywood bench
where noise and vibration will be more noticeable.
2. Hardware to mount this saw to a workbench is NOT
supplied with the saw. However, we recommend the
hardware used be not smaller than the following.
Description Qty.
Hex Head Screw. 1/4-20 x length required................. 3
Flat Washers, 1/4 l.D................................................... 6
LockWashers,1/4 l.D ....... ............................................ 3
Hex Nuts. 1/4-20.......................................................... 6
3. A soft foam padto.place between your scroll saw and
workbench is NOT supplied with the saw. However,
we highly recommend the use of such a pad to
reduce noise and vibration.
Description Qty,
Soft foam pad such as carpet padding,
; y 24‘‘x12"x 1/2T................................................................... 1
Do NOT over tighten mounting bolts - leave some
cushion in the foam pad for absorbing noise and
vibration.
4. if you prefer to mount yoiir saw to a leg set, we rec­
ommend the leg set tor bench top toots which is
available through Sears Retail Stores. The number of
this leg set is 0-22244. This leg set is an optional
accessory and instructions to nnount the scroll sayv to
this leg set are included in the leg set package.
12