Sears 113.235501 - Manual (Page 18)

maintenance
WARNING: for your own safety, turn switch “OFF”,
remove key and remove plug from power source
outlet before maintaining or lubricating your saw.
GENERAL
An occasional coat ol paste wax on the work table will
allow the wood being cut to glide smoothly across the
work surface ^ ^ ^ ^ ^ ^ ^
MOTOR
If the power cord is worn, cut or damaged in any way,
have it replaced immediately.
Do not attempt to oil the motor bearings or service the
motor intema! parts.
ARM BEARINGS
Lubricate the artp bearings after 10 hours of use. Re-oil
after ©very 50 Hours of use or whenever there is a squeak
coming irom the bearings.
1. Turn saw on its side.
2. Squirt a generous amount of SAE 30 oil around the
shaft end arid bronze bearing.
3. Let the oil soak in overnight in this position.
4. Next day repeat the above procedure for the opposite
side of the saw.
wiring diagram
WARNING: To avoid fire or shock, use only recom­
mended service parts and reassemble exactly as
originally assembied.
18