Removing and instailing biades – Sears 113.235501 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
removing and Instailing biades
2. Remove blade by pulling forward on blade and
then lifting the blade through the access hole in the
table.
Slight downward pressure against the upper arm
may be Helpful when removing blade from upper
holder.
SLIGHT PRESSURE HERE
BLADE GUARD REMOVED
FOR CLARITY
I
3.
Look at the blade holders closely and notice the
blade slots and pin recesses in the blade holder. The
blade holder is made so you can position the blade tor
cutting from the front or one side of the saw.
Cutting from the side of the saw will be necessary
when your workpiece exceeds
16
inches
in length.
For
0® bevel angle only.
BLADE GUARD REMOVED
FOR CLARITY
1 0