Winco RP25/C - Manual (Page 11)

Page 9
4200-00 60706-246
VOLTAGE SELECTOR SWITCH
POSITION
TERMINALS MINIMUM
VOLTAGE
NORMAL
VOLTAGE
MAXIMUM
VOLTAGE
120/240 SINGLE PHASE
LINE TO LINE
L TO L3 220 240 260
20/240 VOLT RECEPTACLES 0/220 20/240 30/260
LINE TO NEUTRAL L TO N 0 20 30
L2 TO N -0- -0- -0-
L3 TO N 0 20 30
20 VOLT RECEPTACLES 0 20 30
120/208 THREE PHASE
LINE TO LINE
ALL 200 208 220
20/240 VOLT RECEPTACLES 0/200 20/208 27/220
LINE TO NEUTRAL ALL 5 20 27
20 VOLT RECEPTACLES ALL 5 20 27
G3 TO N 5 20 27
120/240 THREE PHASE
LINE TO LINE
ALL 220 240 260
20/240 VOLT RECEPTACLES 0/220 20/240 30/260
LINE TO NEUTRAL
USE CAUTION THIS CONFIGU-
RATION HAS A HIGH VOLTAGE
LEG
G TO N 0 20 30
HIGH VOLTAGE LEG G2 TO N 9 208 225
G3 TO N 0 20 30
20 VOLT RECETPACLES 0 20 30
277/480 THREE PHASE
LINE TO LINE
ALL 46 460 480
20/240 VOLT RECEPTACLE NONE NONE NONE
LINE TO NEUTRAL ALL 240 265 277
20 VOLT RECETPACLE NONE NONE NONE
The table below show the voltages at the terminal lug as well as the receptacles
for all four voltage patterns available through the selector switch.
WARNING - POTENTIAL EQUIPMENT DAMAGE
THE 120/240 VOLT THREE PHASE POSITION HAS A WILD LEG THAT PRODUCES 208 VOLTS LINE TO
NEUTRAL ON G2. BE SURE WHEN CONNECTING TO YOUR PANEL OR LOAD THAT YOU MATCH THE
WILD PHASE ON THE GENERATOR TO THE WILD PHASE IN YOUR PANEL OR LOAD. FAILURE TO DO
SO WILL RESULT IN 12O VOLT DEVICES RECEIVING 208 VOLTS. YOU MUST ALSO MATCH YOUR
ROTATION.