Repair kits and replacement parts, Wiring instructions for cable plug – Wilkerson E28 User Manual
Page 2
E18/E28 Slow-Start / Quick Dump Valve and Accessories
83-273-000
Muffler
Filter
Spring
Slide
Valve
and
O-Ring
Bottom
Valve
Assembly
Bottom
Plug
Cap
O-Ring
Seal
Adjusting
Needle
Adjusting
Needle
Seat
Actuating
Valve
Inlet Port (1)
Actuating
Valve
Outlet Port (2)
Actuating
Valve
Cap
Screws
Upper
Piston
and
O-Ring
Lower
Piston
and
O-Ring
Unit
Body
Valve
Spring
Exhaust
Location
Inlet Port
Outlet Port
REPAIR KITS AND REPLACEMENT PARTS
Actuating Valve with KR mount 24 VDC ................... VRP-95-776
Actuating Valve with KR mount 120 VAC .................. VRP-95-777
Actuating Valve with C.N.O.M.A mount 24 VDC ....... VRP-95-778
Actuating Valve with C.N.O.M.A mount 230 VAC ...... VRP-95-779
Muffl
er
....................................................................... VRP-95-780
Adjusting Needle Kit ................................................. VRP-95-786
Repair
Kit
.................................................................. VRP-95-782
Valve / Spring Kit ...................................................... VRP-95-781
Replacement O-ring Kit ............................................ VRP-95-783
E18 Body Cap Kit ..................................................... VRP-95-784
E28 Body Cap Kit ..................................................... VRP-95-785
WIRING INSTRUCTIONS FOR CABLE PLUG
1. Remove the holding screw (A) from the cable plug, and pry the
contact holder (B) from the plug case (C) (see Figure 1).
2. Remove the gland nut (D), thrust washer (E) and gland (F) from
the plug case and slide each part over the multiconductor cable
in the order removed. Insert cable through the plug case (see
Figure 2).
3. Strip the cable as shown in Figure 2.
4. Insert conductors into contacts in contact holder, as shown in
the wiring schematic, and securely tighten the contact screws
to retain the conductors.
5. Work contact holder back into the plug case and snap it into place.
6. Slide the gland, thrust washer and gland nut into the plug case.
Tighten the gland nut to provide strain relief for conductors.
7. Reinsert the holding screw.
8. To connect the cable plug to the solenoid operator, push the
plug onto the male terminals and tighten the holding screw.
2
1
FIGURE 2
B
1/4"
1'
PLUG
(EQUIPMENT
GROUND)
SOLENOID
PRY
SLOT
A
FIGURE 1
D
B
C
F
E
A
D
F
C
E