VACUUBRAND Exhaust waste vapour condenser Peltronic - Manual (Page 18)

page 18 of 41
Attention: The condenser will start automatically after
sufficient cooling down. It is your responsibility to ensure
that automatic start-up of the condenser will not lead to
any dangerous condition. Provide appropriate safety mea-
sures.
Maintenance and repair
In order to comply with laws (occupational, health and
safety regulations, safety at work law and regulations for
environmental protection) equipment can only be returned
when certain procedures (see section ” Notes on return
to the factory”, pg. 35) are followed.
➨
Never operate the equipment if parts are disas-
sembled.
➨
Switch off the exhaust waste vapor condenser Pel-
tronic™. Disconnect the electrical power cord and
wait five seconds before starting maintenance to al-
low the capacitors to discharge.
➨
Note: The exhaust waste vapor condenser Peltronic™
may be contaminated with chemicals, which have been
processed during operation. Ensure that the exhaust
waste vapor condenser Peltronic™ is completely de-
contaminated before maintenance commences.
+
Take adequate precautions to protect people from the
effects of dangerous substances if contamination has
occurred. Use appropriate protective clothing, safety
goggles and protective gloves.
+
Never operate a defective or damaged exhaust
waste vapor condenser Peltronic™.
+
Isolate the exhaust waste vapor condenser Peltronic™
from the vacuum system before starting maintenance.
NOTICE