USL RTM-100 - Manual (Page 6)

Page 6
Disposal and Recycling
Wheelie-Bin Symbol
This symbol is attached to this product in compliance with the EU Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE). Its purpose is to deter the improper disposal
of this product and to promote reuse and recycling.
Proper Disposal
In conformance with the Directive, at end of life, this product should be either sent to an appropriate recycling
facility for disassembly and recycling or returned to the supplier. Under no circumstances should this product
be deposited in a landfill for disposal.
Hazards of Noncompliance
Electrical and electronic products may contain chemicals which can leach into the groundwater and cause
health concerns through contaminated drinking water. Failure to dispose of this product in compliance with
the WEEE Directive may result in penalties as determined by local ordinance. Please contact your dealer or
USL, Inc., with questions regarding the proper disposal of this or any other USL product. USL, Inc. contact
information: USL, Inc., 181 Bonetti Drive, San Luis Obispo, CA 93401-7397, USA. Phone: +1 805 549 0161
Fax: +1 805 549 0163 www.uslinc.com
The RTM Package Components
A standard RTM-100 Series package contains a user manual, an RTH-100
handheld remote control and wireless charging case, an RTP-100 wireless
server module with Ethernet cable and power receptacle adapter, an RTC-
100 charging pad with power supply and associated cables.
Setup
1. Connect one end of the Ethernet cable to the RTP-100 Wireless Server Module upper port and
connect the other end of the Ethernet cable to the cinema network.
2. Plug the RTP-100 Wireless Server Module directly into a power source or via the provided power
cable.
3. Wait for approximately four minutes for unit to become fully active. The user will see three lights on
and one light off when confirming unit fully activated.
4. Turn on / wake the RTH-100 Handheld Remote Controller by pushing the button located on the top of
the unit or on the face of the touchscreen.
5. Follow the screen prompt and slide the touchscreen button from left to right to unlock the Handheld
Remote Controller.
RTH-100
Handheld Remote Con tro ller
RTP-100
Wireles s Server Mod ule
RTC-100
Charging Pad