Top Flite TOPA0955 - Manual (Page 26)

26
o 5 . Glue all of the components into the fuselage .
Install the back/head rest first followed by the floor,
instrument panel and side panels .
Note: The side
panel with the throttle quadrant goes on the left side .
o 6 . Glue the back deck behind to the top of the
fuselage behind the cockpit area .
o 7 . We have found that the 1/7th scale WWII
American Pilot bust from Century Jet Models works
well in this model . They offer both a full body (CJMQ
9038) and a bust . You will have to cut away some
of the body to fit the full body pilot . This may make
you consider using the bust only . (CJMQ 9036) Both
versions require minor assembly and are unpainted .
If you are installing a pilot glue him in place now . If
you will be doing this later, skip installing the canopy
until you have the pilot completed .
o 8 . Glue the canopy to the covering with Super Z
RC56 canopy glue . Tape the canopy in place until the
glue dries .
INSTALL THE PROPELLER AND SPINNER
o 1 . The spinner included with this kit can be
tightened against the propeller without the use of a
drive washer .