Top Flite TOPA0955 - Manual (Page 12)

12
o o 10 . Using a motor tool or file, grind a flat spot
on the end of the axle .
o o 11 . Install the wheel onto the axle . Apply thread
locker to the set screw and tighten the set screw
against the flat spot on the axle .
o o 12 . Apply a piece of masking tape to the surface
of the wing at each end of the landing gear . You need
to transfer the exact center line of the landing gear to
the tape . Draw a line on the tape that is directly down
the center of the landing gear wire .
o o 13 . Tape the landing gear door onto the landing
gear . Be sure to center the door in the opening,
leaving an equal spacing between the door and the
opening on both the leading edge and trailing edge
of the door .
o o 14 . Apply another piece of masking tape to
the door in line with the landing gear wire . Using the
lines you previously drew at each end of the landing
gear, draw a line on the tape you just applied to the
door . This line represents the center of the landing
gear wire . From the center of the axle measure up
2-1/8" [54mm] and draw a line perpendicular to
the line representing the landing gear wire . From
that line measure up another 2" [51mm] and make
another line .