Toa VS-900 User Manual
Page 14
1-4
CHAPTER 1. SUBSTATION OPERATION
2.1.2. Calling by Lifting the Handset (only when the RS-190 and RS-191 are combined)
Step 1. Lift the handset.
Calls the designated master station.
The RS-190's call lamp flashes.
[System pre-programming]
The master station corresponding to the substation must
be registered by system programming at the time of
installation.
Step 2. If the master station responds, a brief call tone is
sounded through the handset speaker.
The call lamp mode changes from flashing to
steady-on state.
Speak into the handset.
Step 3. If the handset replaces or the master station
replaces the handset or presses the [C] key, the
conversation is terminated.
The call lamp is extinguished.
Brief call tone
See also other documents in the category Toa Safety:
- C-A771DM (2 pages)
- C-A854H (1 page)
- C-BC100T (2 pages)
- C-BC11 (1 page)
- C-BC200H (4 pages)
- C-BC200K (4 pages)
- C-BC20U (1 page)
- C-BC450PM (4 pages)
- C-BC511A (4 pages)
- C-BC511C (2 pages)
- C-BC511P (4 pages)
- C-BC511U (4 pages)
- C-BC511W (4 pages)
- C-BC704PB (8 pages)
- C-BC704U (8 pages)
- C-BC704W (12 pages)
- C-BC711P (4 pages)
- C-BC711W (4 pages)
- C-BC771PM (6 pages)
- C-BC850U (6 pages)
- C-BC850W (6 pages)
- C-BL20 (1 page)
- C-CC351A NTSC (24 pages)
- C-CC514 NT (44 pages)
- C-CC714 NT (82 pages)
- C-CC514 (2 pages)
- C-CC514 (22 pages)
- C-CC714 NT (36 pages)
- C-CH100 (12 pages)
- C-CV854D-3 CU (16 pages)
- C-IF500 (8 pages)
- C-PH200 (16 pages)
- C-RM1000 HV (60 pages)
- C-RM700 (56 pages)
- C-VD6 UK (4 pages)
- CT-0420SG (1 page)
- CT-10VFGA (1 page)
- VS-900 (56 pages)
- RS-150 Manual (2 pages)
- RS-150 Installation (1 page)
- RS-190 (2 pages)
- RS-442 (2 pages)
- RS-450 (2 pages)
- RS-480 (2 pages)