Toa C-CC354A PAL User Manual
Page 13
13
Backlight Compensation Setting
This function prevents an object from becoming too
dark to be viewed due to backlight.
•
Backlight compensation setting screen
Each item represents the size of the screen area used
to detect backlighting.
•
ON 4/4: Whole screen
•
ON 3/4: 3/4 screen (lower screen making up 3/4 of
the whole screen)
•
ON 2/4: 1/2 screen (lower half of the whole screen)
1. Move the [
] cursor using the
or
key to
select OFF, "ON 4/4", "ON 3/4", or "ON 2/4".
Note
The [
] cursor is set to "OFF" when the Backlight Compensation switch is set to OFF or when
"NORMAL" or "MANUAL" is selected on the Wide Dynamic Setting Screen.
2. Press the [SET] key to confirm the selection.
•
When "OFF" is selected, the display returns to the initial screen.
•
When "ON" is selected, the backlight compensation setting screen of the selected size is displayed.
•
Backlight Area Setting Screen
Set the area that detects backlighting on the screen of
the size selected above.
Each area created by splitting the backlight
compensation setting screen into 12 segments can be
individually set as "Valid" or "Invalid," as shown in the
figure. The figure on the right shows an example when
set to "ON 3/4."
1. All of Area A flashes. Set the area as "Valid" or
"Invalid" using the
or
key.
•
To register as Valid, leave the area in the
condition shown in Figure 1.
•
To register as Invalid, switch the area to the
condition of Figure 2.
2. Press the [SET] key to confirm the setting.
All of Area B flashes.
3. Repeat Steps 1 and 2 above to perform these
settings for all screen areas. After the setting of
Area L is completed, the display returns to the initial
screen.
Figure 2 : Invalid