Toa HY-MS7W-WP - Manual (Page 2)

2
• Avoid touching the bracket’s sharp metal edge to
prevent injury.
• Do not place heavy objects on the bracket as this
may cause the speaker to fall or break which may
result in personal injury and/or property damage.
In addition, the object itself may fall off and cause
injury and/or damage.
• Do not stand or sit on, nor hang down from the unit
as this may cause the speaker to fall down or drop,
resulting in personal injury and/or property damage.
• Have the bracket checked periodically by the shop
from where it was purchased. Failure to do so may
result in corrosion or damage to the bracket that
could cause the speaker to fall, possibly causing
personal injury.
Indicates a potentially hazardous situation which,
if mishandled, could result in moderate or minor
personal injury, and/or property damage.
cAUTION
2. geNerAL DeScrIpTION
The HY-MS7 Series brackets are intended for mounting the HX-7B-WP or HX-7W-WP Speaker System to the
wall under outdoor eaves. These brackets also have provision for mounting the MT-200 Matching Transformer*
directly to this bracket.
* This matching transformer is used to convert low impedance into high impedance 100 V line or 70 V line.
3. NOTeS ON INSTALLATION
• Observe the following instructions when installing the speaker system.
Failure to do so could adversely affect their intended weather-proof
and splash-proof capabilities, leading to malfunction.
· Install the speaker system in locations not exposed directly to rain,
such as under the eaves.
· All speaker modules must point downward from the horizontal.
• When installing the speaker, ensure all rear angle bars* are set to the
same directivity angle mode. If different directivity angle modes are
combined, the HY-MS7 Series’ bottom bracket cannot be mounted to
the wall bracket.
* The bracket bars used to join individual speaker modules at the rear
of the speaker. For instructions on changing the directivity angle,
refer to the instruction manual supplied with the HX-7B-WP or HX-
7W-WP speaker.
• Horizontal speaker installation not possible.
4. MOUNTINg DIAgrAM
[component disassembly] [completed installation]
Horizontal
[Vertical installation]
T-bracket
L-bracket
HX-7B-WP or HX-7W-WP
Speaker System
Mode bracket
Wall bracket
Bottom bracket