Toa H-2WP - Manual (Page 9)

9
6. OUTDOOR USE (H-2WP ONLY)
6.1. Waterproofing
The H-2WP's base frame has a gasket for watertightness.
To completely prevent water from getting into a gap
between the base frame and wall or ceiling panel, apply
caulking agent over the inside of the gasket before
mounting the base frame.
6.2. Speaker Mounting Angle
When mounting the H-2WP speaker on a wall, to ensure
its watertightness it must not be tilted any more than 45
degrees up from its downward-facing position.
Notes
• The H-2WP features drip-proof construction. However, do
not dash water over it when cleaning as this may cause
damage to the speaker components.
• When installing the H-2WP outdoors in a snowy area,
protect the speaker so that it is not covered with snow.
Gasket
Caulking agent
45
45
7. REPAINTING THE FRONT GRILLE
Follow the procedures below to change the color of the grille.
1. Wipe dirt off the front grille with a soft cloth moistened with a detergent before painting. Do not use volatile
liquids such as thinner.
2. Uniformly spray a thin coating of paint over the grille changing the spraying positions gradually.
Notes
• Do not use a roller or brush to paint because the meshes of the grille could be clogged with paint.
• Use paint that is appropriate for the composition of the front grille (grille and frame).
[H-2] Grille: Rolled steel plate
Frame: Fire-resistant ABS resin
[H-2WP] Grille: Rolled steel plate (zinc plating)
Frame: Fire-resistant ABS resin
• Follow the instructions on the paint when painting.
3. After the paint dries, repeat Step 2 once or twice to repaint.
Note: Be sure to repeat Step 2 at least twice.