Input setting items, Setting, P. 58 – Toa A-9240SHM2 User Manual
Page 58: P.58-a1), P.58-a3), P.58-a2), P.58-a4)
58
10.2.4. Input setting items
(A2) Input channel name setting
I N 1
- - - - - - -
The flashing portion is the cursor position for entering channel name characters.
Select a character from the alphanumeric character list by rotating the Parameter setting knob, then move the
cursor with the Right shift key.
Entering a new name overwrites the existing name, if there is.
To delete the character, select [ _ ] (under-bar) with the Parameter setting knob. A space character cannot be
entered.
Up to 7 characters can be used to set the name.
Even when an input channel name has been set, some setting screens display the channel number, not the
set name.
When an input channel is stereo-linked (
), the name entry screen only for the odd channel is
displayed.
(A3) Paging ON/OFF setting
P A G I N G
O F F
Unless otherwise specified, use the Parameter setting knob for each parameter selection.
(A1) Input gain setting
I N 1 - I N 1 : O N
0. 0
Select the input channel using the Input channel selection key.
Confirm the selection by setting the Input channel ON/OFF key to ON.
Set the input channel gain using the Input volume control.
(A4) Input Sensitivity setting
(when the D-001T/R is used)
I N 1 - S E N S I T I V I T Y
-
1 0
Set whether or not to use this input channel for paging.
When set to ON, this channel can be used as paging source, enabling priority setting and zone paging setting
as well.
Note
Changing the parameter in this item during paging broadcast interrupts all paging calls being made through
any channel.
1 – 8 (default: 1)
ON (default), OFF
–∞, –70.0 dB to +10.0 dB (default: 0.0 dB), 0.5 dB steps
Setting Range
Input Channel Selection
Channel Control
Channel Gain
7 characters (default: IN1 – 8)
Setting Range
ON, OFF (default)
Setting Range
Select the input sensitivity from the following 9 levels depending on the input sources:
–60, –54, –48, –42, –36, –30, –24, –18, –10 dB (default)
Setting Range