Tii SVMWT - Manual (Page 2)

NOTE: Wires do not require stripping for
terminations to the IDC rockers
described in the following steps.
4. Insert the Digital Voice Service wires from
ATA / EMTA into wire guides simultaneously
until they bottom-out. While holding the wires
in position, terminate them into the MTA (Blue)
rocker by lowering it to the full DOWN position.
(See Fig. 2) If the ATA / EMTA is supplying
power to the SVM, the green MTA power LED
provided on the line will start to blink.
5. Disconnect the customer premises wiring from
the Telephone Network Interface Device
(NID). Install a wire pair from the Telephone
NID (where the customer premises wiring was
disconnected) to the rocker labeled Tel
(Green/Red) on the SVMWT. Follow the
procedure described in step 4 for the wire pair
termination.
6. Re-terminate customer premises wires onto
the Green/Red rockers provided on the
SVMWT. Straighten the ends of the wires, cut
kinked and stripped ends. Follow the
procedure described in step 4 for the wire pair
termination.
7. If a security alarm is installed at the customer
premises, remove the Green/Red wire
jumpers from the Orange S-Out and S-In
rockers by lifting the rockers up and pulling the
jumper wires out. (See Fig. 1)
8. Terminate the wire pair going to the security
alarm system in the rocker marked S-Out.
Terminate the wire pair returning from the
security alarm system in the rocker marked S-
In.
9. To keep wire pairs organized, route them
through the molded wire looms. (See Fig. 2)
10. IMPORTANT: This unit MUST be reset during
initial installation. Refer to procedure
described below for MTA Power Reset.
RESET
1. Confirm that the power is connected to the
MTA (Blue) rocker of SVMWT.
2. Gently push the reset button once with a blunt
object to ensure the service to the customer is
switched from Digital to Telco. (See Fig. 1)
Figure 2
NOTE:
THE RESET SWITCH IS DISABLED DURING
RINGING VOLTAGE PRESENCE AND TEN
SECONDS AFTER THE LAST RINGING VOLTAGE.
CAUTION:
TO AVOID PERMANENT DAMAGE TO RESET
BUTTON DO NOT USE EXCESSIVE FORCE OR A
POINTED OBJECT TO ACTIVATE THE RESET
BUTTON.
TEST CLIPS
(NOT INCLUDED)
WIRE
LOOM
TEST POINTS
FULL UP POSITION