Compaq 2000 - Manual (Page 45)

4-2 Compaq 2000 Series UPS Operation and Reference Guide
Placing the UPS in Configure Mode
The Compaq 2000 Series UPS models can enter the Configure mode while in
the Operate or Standby mode.
2
3
4
1
Figure 4-1. Configure mode controls
1 ON LED (LED 16)
2 ON button
3 STANDBY button
4 TEST/ALARM RESET button
To place the UPS in Configure mode, press the ON (
2) and TEST/ALARM
RESET (
4) buttons simultaneously. Release the buttons when the
acknowledgement beep sounds.
IMPORTANT: If the STANDBY button is pressed while in the Configure mode, the UPS will
enter Standby mode, and power to the load segments will cease.
In the Configure mode, the front panel LED display changes function. The
LED display and button controls allow the user to monitor, and to change, the
UPS configuration parameters.